Cino Fuzzyscan MBC6890 series Betriebsanweisung PDF herunterladen (Seite 23)

(5) Scan the “SPP Slave Mode” barcode command, the imager

gives 2 short beeps and imager LED gives red blinks.

SPP Slave Mode

Quick Set Command

Your imager is now ready to be discovered by a remote

Bluetooth master device.

After scanning the “SPP Slave Mode” barcode command, the

imager will enter “Sleep State”, if the radio link is not built within

1 minute. You can press the trigger switch to revert it to SPP

Slave process. If you want to switch it back to “Uninstall State”,

please press and hold the trigger switch for 2 seconds.

(6) Execute the Bluetooth Discovery procedure from the host

system equipped with the remote Bluetooth master device.

(7) Check whether "MBC6890" is shown among the discovered

Bluetooth devices in your host system. For example, the device

name “CINO MBC6890” will be shown on “Found Bluetooth

Devices”

(8) Establish the radio link between MBC6890 and remote

Bluetooth master system. If the PIN Code or Passkey is

requested for security connection, please enter “00000000”.

Double click the “CINO MBC6890” on the found Bluetooth

devices. You will see the “CINO SPP” service on the imager.

Double click the “CINO SPP” service to establish the connection

between MBC6890 and remote Bluetooth master system.

(9) The MBC6890 imager gives 4 beeps in ascending tone to

indicate the radio link built. After that, the imager LED will give

green blinks at regular intervals to indicate that the imager is in

the radio-connected state.

The installation procedures will vary depending on different

remote Bluetooth host systems, operation systems and

Bluetooth drivers. Please follow the respective procedures to

build the connection accordingly.

MBC6890 User’s Guide

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 53 54

Keine Kommentare

Cino Fuzzyscan MBC6890 series Betriebsanweisung Seite 23